FuelCheck® Fiberoptic Pipeline Interface Detection doc. #600203 Provides instantaneous and highly sensitive interface detection in shared product pipelines Very low cost of ownership because no power or wiring is needed at Probe location on pipeline Probe is COMPLETELY fiberoptic and thus inherently safe When Controller is located indoors, system is completely immune to lightning Probe can be located up to 2 km away from Controller using inexpensive “offthe-shelf” fiberoptic cable Extremely cost-effective alternative to conduit and hard-wiring Uses light refraction rather than density to detect product interfaces Refractive index measurement is extremely sensitive to small differences in composition; thus, much more difficult batch cuts are possible than with density When properly applied using tandem sensor technique, vast reductions in transmix volumes are typical Probe installs flush with pipeline so pigging can be accomplished without retracting Probe
RkJQdWJsaXNoZXIy NDE1MjE4