TYPCIAL DEF-Trac HEAT TRACED / INSULATED LAYOUT NOTE: THIS IS A GUIDE FOR LAYOUT ONLY, FOLLOW ALL THERMON INSTRUCTIONS FOR PROPER WIRING, CONNECTION AND INSTALLATION REQUIREMENTS 1. Ambient Control Thermostat – (OmegaFlex Part Number DF-B4X-15140 / non-hazardous location or DF-B7-15140 / hazardous location) Used to control a single heating circuit or as pilot control of a contactor switching multiple heat tracing circuits. Typically installed near a building or structure out of direct sunlight. 2. Terminator Power Connection Kit – (OmegaFlex Part Number DF-DP) Used to provide the power connection or can also be used as a splice kit if terminal block connections are required by code. Heat trace connections are made utilizing the cable termination kit. (OmegaFlex Part Number DF-PETK-1D / sold separately) 3. Terminator Splice Kit – (OmegaFlex Part Number DF-DS/DE) Used to provide splice connection at tee’s or can be used as end of circuit termination. For a tee splice, heat trace connections are made utilizing the cable splice kit. (OmegaFlex Part Number DF-SCTK-1D / sold separately) Or end of circuit heat trace connections are made utilizing the cable termination kit. (OmegaFlex Part Number DF-PETK-1D / sold separately) 4. DEF-Trac End Fitting – (OmegaFlex Part Number DF-FST-xx) Field attachable Stainless Steel end fitting with NPT thread. 5. DEF-Trac Heat Traced Piping – (OmegaFlex Part Number DF-FSPHT-xx) Flexible Stainless Steel corrugated piping, insulated and heat traced. 6. Heat Shrink Sleeve – (OmegaFlex Part Number DF-HTFBD-xx) Provides sealing onto the outer insulated jacket as well as over the back hex nut of the DEF-Trac fitting. One kit includes two heat shrink sleeves, one for the insulated piping and one for the DEF-Trac fitting. The same heat shrink will fit on both, the insulated piping and the DEF-Trac fitting. Alternatively, the Bundle / Fitting Self Sealing Kit (OmegaFlex Part Number DF-FAK-7) can be used to seal the ends. This would be used in place of the heat shrink sleeves. 7. Fixing Tape – (OmegaFlex Part Number DF-FT-1L) Used to attach the heat trace to the uninsulated piping, tees, valve or end attachments.
RkJQdWJsaXNoZXIy NDE1MjE4