Hannay Reels, Inc. Phone 518-797-3791 Toll Free 1-877-GO REELS (467-3357) FAX 1-800-REELING (733-5464) USA or FAX 518-797-3259 (International) www.hannay.com [email protected] 2 Standard Configuration Shown MANUAL OR POWER REWIND REELS To handle single 1" through 1-1/2" I.D. hose. • A strong, heavy-duty reel. • Gear-driven crank rewind or chain and sprocket drive powered by an electric, hydraulic or compressed air motor. • Optional auxiliary crank rewind for power rewind reels. • Crank rewind reels supplied with pinion brake and power rewind reels with a comet brake. • 90 ° ball bearing swivel joint with 1-1/2" female NPT threads and 2" victaulic groove. • Flanged riser with 1-1/2" female NPT threads. • Other sizes and/or threads can be furnished and must be specified. • Standard inlet, outlet riser, hub assembly are aluminum for jet fuels. • Stainless steel, at extra cost. • Rollers and roller mounting brackets are accessory items. Specify roller position. • Pressures to 600 psi (41 bar) • Temperatures from -40°F to +175° F (-40° C to +79° C). • Consult factory for other pressures & temps. S E R I E S Note to Designers and Engineers: The reels shown in this catalog are the standard of the industry. These models reflect various installation and performance requirements. The high quality of our standard steel construction is only the beginning. Hannay Reels offers any size configuration to fit a defined space, and we construct many models of reels of aluminum or stainless steel. Specifically, we use 5000 and 6000 Series aluminum and 304 stainless steel in the manufacture of frames, discs, drums and internals as well as other structural components. This type of construction eliminates the need for maintenance repainting and part replacement due to rust or corrosion. The drum diameters of the reel models listed have been used successfully for many years. However if your application requires a larger drum diameter to meet API hose standards, please remember it will also increase the envelope dimensions for the reel and may incur an extra cost. Please note: Jet fuels require non-ferrous internal piping. Hannay Reels offers aluminum or stainless steel internals for 1" to 4" I.D. hose reels. Please consult factory on any fuel handling questions. For the many accessories and components available on our standard reel models such as roller guides, switches, brakes and locks, etc., please refer to our Ordering & Accessory Guide H-0415-OA. Paint Notice To meet the requirements and performance of vehicle and OEM apparatus paints we recommend our reels be painted with the same or equal paint as used on the specific apparatus the reel is being mounted on. Hannay Reels will supply any model or custom reel or part with an automotive primer or rust preventative oil finish upon request, allowing application of final coating at your facility. Or at additional cost Hannay can prime / pre-paint all material before final assembly. In today’s regulatory environment this would be the most cost-effective way to meet your finishing standards. Consult factory for other optional finishes Standard finish is oven cured enamel. High performance finishes for demanding and corrosive environments are available at an additional cost. Consult factory for specific requirements.
RkJQdWJsaXNoZXIy NDE1MjE4