RECEIVER/CONTROLLER SPECIFICATIONS FREQUENCY.............................................................433.92MHz POWER SUPPLY.......................................................120/240VAC or 12/24VDC RECEIVER OUTPUT MAX LOAD......................Up to 24Amps RECEIVER OUTPUTTYPE....................................24Amp Dry Contact Relay CONSTRUCTION...................................................Rugged weatherproof polymer enclosure ANTENNA.................................................................external antenna/coax included WIRING CONNECTIONS....................................pre-wired to meet customer requirements SERIAL COMMUNICATION Optional J1939 CAN bus/RS232 interface to OEM serial networks TOTAL SYSTEMWEIGHT......................................10lbs ROHS LEAD-FREE COMPLIANT Fixed-frequency remote E-Stop switch operates at 433MHz using two double “A” batteries.Transmitter is energized only when E-Stop switch is activated. BatteryTest button shows a “low battery” flashing LED on the E-Stop switch as well as on the receiver/controller unit.A ‘low battery’ alarm or indicator lamp output is supplied for auxiliary low battery warning.Typical battery life is one to two years but routine battery testing and replacement is recommended.Operating range up to 1000ft. E-Stop Receiver/ Controller Easily interfaced with electrical, pneumatic, hydraulic, nitrogen, or mechanical plant shut-off equipment. Systems will operate with 12/24VDC or 120/240VAC power supplies. Receiver/Controller outputs can be specified as 12/24VDC, 120/240VAC, dry contact, RS232, or J1939 CAN bus. BASEEngineering can also supply electric/pneumatic interface solenoids on request. Transmitter E-Stop switches are rated for use in hazardous locations but standard receiver/controller units are not rated explosion proof and are typically hard wired by electrician in a non-hazardous electrical control area. Receiver/controller units are provided pre-wired and ready for power supply and E-Stop connection.Antenna and coax cable are also provided for outside antenna mounting allowing maximum operating range. Explosion-proof receiver/controller electrical enclosures are available on request. Fixed Mount E-StopTransmitter Pressing the Emergency Stop button causes the receiver/ controller unit to trigger a shut-down. The system cannot be rebooted until the E-Stop button is pulled out and a manual receiver/controller reset is performed. E-Stop buttons are dual contact – dual channel and comply with global E-Stop switch requirements. Systems will fail safe, triggering an automatic E-Stop with any loss of main line electrical power supply to the receiver/controller unit. Modular DIN Rail components for easy installation and maintenance Intrinsically Safe, Explosion Proof handheld remote E-Stop available for any system Operator can shutdown any LPG pumping or tank equipment fitted with BASE E-Stop hardware. Contact our factory to help specify your application. BASEENGINEERING INC. 600 Rothesay Ave • Saint John, NB • Canada • E2H 2H1 North America Toll Free 1.800.924.1010 • International 01.506.635.2280 • Fax 506.635.2281 BASEng.com
RkJQdWJsaXNoZXIy NDE1MjE4