EATON Aerospace Group TF100-95D May 2013 3 Option Description A Adds pilot valve to basic unit to provide bottom loading control when used with Model 64079 jet level sensor or optic sensing probe system C Replaces victaulic inlet fitting with 3-inch TTMA pipe flange. Special order only. Ordering Data Item Description Whittaker Model Eaton Model Comments – ApplicableTo Carter Units 3-inch internal valve for off-loading only F660 64129 Eaton models will not open when used with a positive displacement pump in the off-loading system — not sensitive to flow rate up to 1,100 gpm (4163 l/min) 3-inch internal valve for bottom loading and off-loading F660A 64129A Same comments as above Level sensor, no options F613 64079 Precheck and collector drain cans standard on Model 64079 Level sensor with mounting stud F613A 64079A Mounting stud located outside of precheck and drain cans for better control Option Description A Adds stud to basic unit to provide mounting and level adjustment — ½-13 UNC-2B thread B Dual jet level sensor C Jet level sensor with short body level sensor Model 64129 3-inch Bottom Loading Valve Option A or C shown (right) may be added to change the function or configuration of the unit Model 64079 Level Sensor Option A, B or C shown (right) may be added to the basic 64079 model number when used with Model 64129A Bottom Loading Valve Equivalent Part Numbers — Whittaker To Eaton The following table presents the equivalent Eaton’s Carter models to replace Whittaker units: Dimensions shown in inches (mm) Dimensions shown in inches (mm) Drain Connection Precheck Adjustment Gate Inlet Outlet
RkJQdWJsaXNoZXIy NDE1MjE4