Retail Petroleum Equipment

Rev. Date: 02/10/10 General Description Slim, low profile, easy mounting from below or above the deck. Luminaire sides are rugged cast aluminum with high performance extruded aluminum heatsink specifically designed for LED. Luminaire mounts directly to the canopy deck and is secured in place with extruded aluminum trim frame. Luminaire housing is provided with factory applied foam gasket and provides for a watertight seal between luminaire housing and canopy deck. Suitable for use in single or double skin canopies with 12" (305 mm) or 16" (406 mm) wide panels. Designed for canopies of 19 – 22 gauge (maximum 0.040" [1 mm] thickness). Watertight driver compartment is constructed of anodized extruded aluminum with stainless steel end panels for exceptional corrosion resistance and thermal performance. Driver is factory wired to the luminaire housing via weather resistant flexible power conduit. Driver compartment is secured to the canopy ribs of the canopy deck with #14 Tek-screws (by others). Five year limited warranty on luminaire. Electrical Modular design accommodates varied lighting output from high power, white, 6000K ( +/- 500k per full fixture), minimum 70 CRI, long life LED sources. 120–277V 50/60 Hz, Class 1 LED drivers are standard. 347–480V 50/60 Hz driver is optional. LED drivers have power factor >90% and THD <20% at full load. Units provided with integral 9kV surge suppression protection standard. Surge protection tested in accordance with IEEE C62.41.2 and ANSI standard 62.41.2. Testing & Compliance UL listed in the U.S. and Canada for wet locations and enclosure classified IP66 per IEC 60598. RoHS compliant. International Dark-Sky Association approved. Finish Exclusive Colorfast DeltaGuard ® finish on all cast aluminum components, features an E-Coat epoxy primer with an ultra-durable white powder topcoat. Provides excellent resistance to corrosion, ultraviolet degradation and abrasion. Clear anodized finish on extruded aluminum heat sink with white powder finish on all cast aluminum components is standard. Bronze, black, silver and platinum bronze powder topcoats are also available. The finish is covered by our 10 year warranty. Fixture and finish are endurance tested to withstand 5,000 hours of elevated ambient salt fog conditions as defined in ASTM Standard B 117. Patents U.S. and international patents granted and pending. BetaLED is a division of Ruud Lighting, Inc. For a listing of Ruud Lighting, Inc. patents, visit www.uspto.gov. Field-Installed Accessories Retrofit Plate Kit 24" x 26" plate used when replacing surface mounted HID luminaires. XA-CR9004& For use on 12" wide deck panels. XA-CR9005& For use on 16" wide deck panels. NO PHOTO AVAILABLE Photometrics Retrofit Plate Kit XA-CRRP90WH Used when replacing recessed HID luminaires in existing open canopies with up to 12" round or square, or 12" x 16 " rectangular deck opening. Remote Motion Sensor Kit Used to control a single or series of fixtures as On/Off controller or Hi/Low controller with HL option (rated for up to 800 watts @ 120V or 1200 watts @ 277V) XA-OMS108-UWL Up to 8' mounting height XA-OMS120-UWL Up to 20' mounting height XA-OMS140-UWL Up to 40' mounting height Position of vertical plane of maximum candlepower. 20' 5' 5’ 10' 10' 20' 0' 15' 15' 25' 25' .5 2 1 10' 15' 5' 0' 5' 10' 15' 20' 20' 25' 25' 30' 30' 0 m 4.6 3.1 9.2 9.2 6.1 3.1 1.5 1.5 4.6 6.1 7.6 7.6 0 m 1.5 1.5 3.1 3.1 4.6 4.6 6.1 6.1 7.6 7.6 35 º 5 30' 30' 9.2 9.2 10 CURB LINE Isofootcandle plot of 6000K, 90 LED petroleum symmetric recessed canopy luminaire at 15' A.F.G. Luminaire with 8,906 initial delivered lumens operating at 350mA. Initial FC at grade. Independent Testing Laboratories certified test. Report No. ITL62990 Candlepower trace of 6000K, 120 LED petroleum symmetric recessed canopy luminaire with 4,224 initial delivered lumens operating at 350mA. All published luminaire photometric testing performed to IESNA LM-79-08 standards. 150 ° 120 ° 120 ° 60 ° 90 ° 90 ° 60 ° 30 ° 1669 417 1252 835 150 ° Candlepower Trace: Vertical plane through horizontal angle of maximum candlepower. 30 ° BetaLED ® Recessed Luminaires CAN-227-PS-RM-09 © 2010 BetaLED ® , a division of Ruud Lighting • 1200 92nd Street • Sturtevant, WI 53177 • 800-236-6800 • www.betaLED.com Made in the U.S.A. of U.S. and imported parts. Meets Buy American requirements within the ARRA.