Retail Petroleum Equipment

Fleet Management Bid Specification SP-7178 01/12 Gasboy│7300 W Friendly Ave│Greensboro, NC 27410 7 6.0 Wireless Nozzle Reader - WNR The wireless nozzle reader shall not have any wires The wireless nozzle reader shall read the data off the passive fuel ring (mounted around the vehicle fuel inlet) and transmit the encrypted data over wireless link to the wireless gateway The wireless nozzle reader shall read the passive fuel ring using contact-less technology with anti- spoofing mechanism to protect against cloning of vehicle devices (recording the pattern that is transmitted by a specific vehicle and creating a clone). The wireless nozzle reader shall transmit the encrypted fuel ring data to the wireless gateway installed in the fuel island using a 2.4 GHz encrypted wireless network communication The wireless nozzle reader shall be a self-contained unit installed on the nozzle. No wires shall be connected to the wireless nozzle reader. The wireless nozzle reader shall have a customized design for most common nozzle types. A special version shall be available to fit high speed nozzles such as Posilock and Wiggins. The wireless nozzle reader shall fit onto existing fueling nozzles and cradles of most common dispensers. The wireless nozzle reader shall be designed from glass-reinforced nylon enabling it to survive harsh fuel environment, mechanical impacts and to withstand ozone, UV and strokes. The wireless nozzle reader shall survive multiple 4 feet drop test on concrete, fuel and oil materials, IP-54 rain and solar radiation. The wireless nozzle reader shall have a green LED light to indicate:  The wireless nozzle reader has detected a passive fuel ring  The wireless nozzle reader is in operation 7.0 Passive Fuel Ring - FuelOpass The passive fuel ring shall be mounted around the vehicle fuel inlet. The passive fuel ring encrypted data shall be read by the wireless nozzle reader using RFID contact-less technology. The passive fuel ring shall be a low cost device designed for vehicle identification and fuel transaction recording only. The fuel ring shall be made of an electrical coil encased in a molded plastic and attached to an ID chip. The fuel ring shall have the following characteristics:  Does not require a hard-wire connection to vehicle module  Passive transponder (No power source required)  No wiring  No RF interferences.  Easy to install (No professional man power shall be required)  Install within a few minutes  Available in various sizes to meet most vehicle requirements  The ID chip shall have an anti-theft and tamper resistant design that will destroy the ID chip when it is removed from the vehicle