2 Performance Primary operating pressures to 300 psi (20 bar) Continuous operating temperature to 150°F (66°C) Containment system pressures to 50 psi (3.45 bar) Individual system components may not have the same ratings as the pipe. Refer to the detailed product information for the specific components to determine the pressure rating for the system as a whole. Composition Primary pipe: Filament-wound fiberglass reinforced epoxy pipe with integral epoxy liner and exterior coating. When classified in accordance with ASTM D2310 and ASTM D2996, the pipe meets the following cell limits: RTRP 11CX-5430. Pipe containment: Filament-wound fiberglass reinforced epoxy pipe. Interstitial space: Dry, graded glass beads secured in place with adhesive backed tape. Fittings: Compression molded or filament-wound fiberglass reinforced epoxy primary fittings. Containment fittings are molded. Adhesive: Ameron PSX™•20 or PSX™•34 ambient-cure, two-part epoxy for all services (including alcohols and MTBE). Joining system Primary: Bell and spigot taper/taper adhesive-bonded joint Containment: Adhesive-bonded clamshell fittings. Parts are compression molded for exact fit and match. Material is identical to primary fittings and is fully Listed by UL for all services, including use in MTBE fluids. Pipe lengths Standard 20 ft. (6.1 m) random lengths 17 to 21 ft. (5.2 to 6.4 m) and 30 ft. (9.1 m) random lengths 27 to 32 ft. (8.2 to 9.7 m) Other lengths up to 42 ft. available upon request. Fittings Primary– Adapters: bell x NPT male1 Flange stub ends1 Adapters: bell x NPT female2 Isolation bushings1 Adapters: spigot x NPT female2 Nipples2 Adapters: spigot x NPT male2 Reducer bushings1 45° elbows1 Repair couplings1 90° elbows1 Sleeve couplings2 End caps1 Tees1 Flange rings1 Dispenser pan penetration fittings1 Containment– 45° elbows1 Couplings1 90° elbows1 Tees1 Termination sleeves1,3 1 Molded fitting 2 Filament-wound fitting 3 2-inch available with or without test valve. 3- and 4-inch available only with test valve
RkJQdWJsaXNoZXIy NDE1MjE4