Retail Petroleum Equipment

27 SUBMERSIBLE PUMPING SYSTEMS SUBMERSIBLE PUMPING SYSTEMS ORDERING INFORMATION XXX YYYYY Z - A - B XXX = Basic Model Designation STP = These standard variable speed and variable length models are capable of up to 10% ethanol with gasoline IST** = These variable speed and variable length models include alcohol-gasoline compatibility (up to 85% ethanol, up to 20% Biodiesel, or 100% Biodiesel). YYYYY = Factory Installed Options Model designations may include one or more of the following characters in alphabetical order: F = Floating suction adapter (1½" NPT female adapter) K = Intake filter screen (IFS, factory installed to PMA) M = MagShell ® (flow enhancing, expanded PMA shell) R* = Model R check valve (24 psi relief/22 psi reset for PLLD) W* = Model W check valve (16 psi relief/13 psi reset for PPM4000) Z = Pump Motor Horsepower Rating VS2** = 2 hp variable speed VS4 = 4 hp variable speed A = Model Length (see table) VL1 = STP variable length range #1 VL2 = STP variable length range #2 VL3 = STP variable length range #3 B = Riser Pipe Length (see diagram) Riser pipe length is expressed as two numeric characters that indicate the total length of the riser in inches. Riser pipes are available from 7" to 60" in 1" increments (additional charge for risers 31" or longer). Notes: *If not otherwise specified, all models are supplied with standard model check valve (40 psi relief / 35 psi reset for MLD, TS-LS300, and TS-LS500). **If not otherwise specified, 2 hp variable speed pump motor horsepower rating is implied for IST models. A typical turbine model designation has up to five components to define the pump being supplied as follows: A B STP Horsepower Model Length Range Model Length Designation 2 hp 59" - 87" VL1 90" - 151" VL2 122" - 213" VL3 4 hp 64" - 92" VL1 95" - 156" VL2 127" - 218" VL3 Model Length (A) Veeder-Root ® is a trademark of the Danaher Corporation. SUBMERSIBLE TURBINE PUMPS