Retail Petroleum Equipment

63 SUBMERSIBLE PUMPING SYSTEMS SUBMERSIBLE PUMPING SYSTEMS A typical turbine model designation has up to five components to define the pump being supplied as follows: STP XXXXX Y - A - B STP = Basic Model Designation Note: Standard models up to 10% ethanol capable. XXXXX = Factory Installed Options HCP model designations may include one or more of the following characters in alphabetical order: F = Floating suction adapter (3" NPT male adapter) *R = Model R check valve (24 psi relief/22 psi reset for PLLD) *Note: If not otherwise specified, all HCP models supplied with standard model check valve (40 psi relief/35 psi reset for MLD, TS-LS300, and TS-LS500). Y = Pump Motor Horsepower Rating 3 = 3 hp fixed speed, 208-230 VAC 5 = 5 hp fixed speed, 208-230 VAC 5H = 5 hp fixed speed, 460 VAC 5G = 5 hp fixed speed, 575 VAC A = Model Length Model length is expressed as three numeric characters that indicate the length of the HCP from the turbine manifold bottom to the pump motor inlet in inches, available from 60" to 200" (additional charge for models 132" and longer). B = Riser Pipe Length Riser pipe length is expressed as two numeric characters that indicate the total length of the riser in inches. Riser pipes are available from 6" to 60" in three inch increments (additional charge and lead time for risers 27" or longer). SUBMERSIBLE TURBINE PUMPS High Capacity SubmersibleTurbine Pump Model Designation System